:	Dec 6, 2004

.

Remove the headliner.

.

Release the 4 drain hoses from the roof opening panel.

.

Disconnect the roof opening panel motor electrical connector.

.

With assistance, remove the roof opening panel assembly.   Remove the 11 bolts.

.

: Do not depress the RH plunger to remove the blind. :   Do not disassemble further if the component is removed for access only. :   Note the fitted position. Remove the roof opening panel blind.   Twist to release the handle.   Depress the LH plunger.

.

Remove the roof opening panel motor.   Remove the 3 Torx screws.   Remove the spacer.

.

Install the roof opening panel motor.   Install the spacer.   Tighten the Torx screws to 4 Nm (3 lb.ft).

.

:   Align to the position noted on removal. Install the roof opening panel blind.   Secure in the guides.   Locate the tensioner peg.   Depress the LH plunger.

.

With assistance, install the roof opening panel assembly.   Clean the component mating faces.   Tighten the bolts to 10 Nm (7 lb.ft).

.

Connect the roof opening panel motor electrical connector.

.

Connect the drain hoses.   Make sure the drain hoses are clear prior to connection.

.

Install the headliner.

.

Using T4, configure a new roof opening panel.

.

If the battery has been disconnected, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panels calibration routine and reset these functions.